Skip to main content

Locations & Pins

A location is one point in the yard: a parking spot, a dock door, a staging position. Locations are what operators pick as a destination on a work ticket, and what an asset can be assigned to.

Drop a Pin​

  1. Choose Drop pin in the tool strip. To start from a specific facility, open that facility's ⋯ menu and choose Add a location. The pin then goes under that facility, even if you click outside its outline.
  2. Click the map where the location is.
  3. A New location row opens in the tree, under the parent Yard Spot suggests, with the name field selected. Type the name and press Enter or click ✓ Accept.

The naming row for a new pin, with a Name field and the accept and cancel buttons

An empty name, Escape or ✕ Cancel discards the pin. While you are placing a pin, Cancel in the instructions above the tree ends the tool.

Where does it land?​

The row shows Lands in ... with the parent Yard Spot suggests:

  • The facility whose outline contains the pin. When outlines overlap, the smallest one is suggested.
  • The site itself, when the pin is outside every outline. These appear in the tree under Site locations.
  • If you started from a facility's Add a location, that facility is suggested while the pin is inside it.

When more than one parent is possible, for example overlapping outlines or a pin dropped outside the facility you started from, the row shows a choice of parents. Pick the right one before you confirm the name.

The parent you confirm is stored. Redrawing outlines later does not move existing locations.

Names

Location names must be unique within their parent. A duplicate shows Name already used.

Add by Coordinates​

If you have the coordinates, open a facility's ⋯ menu and choose Add by coordinates. The form asks for:

FieldNotes
NameRequired.
CapacityOptional. A positive whole number.
Latitude, LongitudeThe point. Required.

Capacity​

A location with no capacity set counts as 1, a single space. Set a larger number for a row or zone that holds several assets. Edit a location and fill in Capacity; it must be a positive whole number. Capacity feeds the full-location warning at the gate. See Capacity & Occupancy.

A capacity pill on a location row with its tooltip open

Moving a Location​

There are two ways to move a location's point.

  • Drag it. Click a location's dot on the map to select it (the tree row is selected too, and the dot grows a ring). With the Select tool active, drag the selected dot to the new spot. It is saved when you drop it.
  • Move pin. Choose Move pin from the location's ⋯ menu, then click the map where the point should go. The cursor becomes a crosshair and the location's marker pulses until you click. Cancel in the instructions above the tree ends it.

The Location Menu​

Each location row has a ⋯ menu. There is no Rename item; use Edit to rename.

The location menu open on a location row, with Move pin among the items

ItemWhat it does
EditName, capacity and coordinates in a form. This is how you rename a location.
Move pinClick the map where the point should go. See above.
Make a gate / Stop being a gateSee Gates.
Move to the siteTake a location out of its facility and place it directly under the site. Only shown for locations that are in a facility. It keeps the same id, so gates and assets that use it are unaffected. If the site already has a location with that name, the move is refused.
DeleteRemove the location. If it is a gate, the confirmation names the gate and deletes it too. See Deleting.

There is no Show on map item. Clicking a location's row selects it on the map, keeping your zoom and panning only if the point is off-screen.

On the map a location is a teal dot and a gate is a violet square, so a gate stands out from ordinary locations. A gate also has a marker in the tree.

Large Facilities​

A facility with many locations shows the first few and a Show N more button. Select a location on the map to open its row in the tree.